ISO 128-50:2001
Technical drawings - General principles of presentation - Part 50: Basic conventions for representing areas on cuts and sections
- Standard No.
- ISO 128-50:2001
- Release Date
- 2001
- Published By
- International Organization for Standardization (ISO)
- Latest
- ISO 128-50:2001
- Scope
- This part of ISO 128 specifies general principles for representing areas on cuts and sections on technical drawings (mechanical, electrical, architectural, civil-engineering etc.) following the orthographic projection methods specified in ISO 5456-2. Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428. NOTE The basic rules for cuts and sections are given in ISO 128-40t1l.
ISO 128-50:2001 Referenced Document
- ISO 10209-1 Technical product documentation; vocabulary; part 1: terms relating to technical drawings; general and types of drawings
- ISO 10209-2 Technical product documentation; vocabulary; part 2: terms relating to projection methods
- ISO 128-24:1999 Technical drawings - General principles of presentation - Part 24: Lines on mechanical engineering drawings
- ISO 5456-2 Technical drawings - Projection methods - Part 2: Orthographic representations
- ISO 6428 Technical drawings; Requirements for microcopying
ISO 128-50:2001 history
- 2001 ISO 128-50:2001 Technical drawings - General principles of presentation - Part 50: Basic conventions for representing areas on cuts and sections
