SAE AMS2516D-1990
Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 Degrees - 400 Degrees C (698 Degrees - 752 Degrees F) Fusion

Standard No.

SAE AMS2516D-1990

Release Date

1990

Published By

Society of Automotive Engineers (SAE)

Status

Withdraw

Replace By

SAE AMS2516C-2003

Latest

SAE AMS2516F-2018

Scope

This specification establishes the engineering requirements for producing thick coatings of polytetrafluoroethylene (PTFE) resin on parts and the properties of such coatings. Primarily to provide dry lubrication, high heat stability, and corrosion protection on parts which operate at not higher than 275 degrees C (527 degrees F) for limited periods or not higher than 245 degrees C (473 degrees F) for extended periods. This coating may also be used as a release film for molds.

SAE AMS2516D-1990 history

• 2018 SAE AMS2516F-2018 Polytetrafluoroethylene (PTFE) Resin Coating High Build@ 698 to 752 °F (370 to 400 °C) Fusion.
• 2013 SAE AMS2516E-2013 Polytetrafluoroethylene (PTFE) Resin Coating, High Build, 698-752°F (370-400°C) Fusion
• 2003 SAE AMS2516D-2003 Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 to 400 °C (698 to 752 °F) Fusion
• 2003 SAE AMS2516C-2003 Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 to 400 °C (698 to 752 °F) Fusion
• 1990 SAE AMS2516D-1990 Polytetrafluoroethylene (PTFE) Resin Coating High Build, 370 Degrees - 400 Degrees C (698 Degrees - 752 Degrees F) Fusion
• 1983 SAE AMS2516C-1983 POLYTETRAFLUOROETHYLENE RESIN COATING High Build@ 370° - 400°c (700° - 750°) Fusion
• 1974 SAE AMS2516B-1974 POLYTETRAFLUOROETHYLENE RESIN COATING High Build, 700° - 750° F (371° - 399° C) Fusion
• 1965 SAE AMS2516A-1965 POLYTETRAFLUOROETHYLENE RESIN COATING High Build, 700 - 750 F (371 - 399 C) Fusion
• 1963 SAE AMS2516-1963 POLYTETRAFLUOROETHYLENE RESIN COATING High Build, 700 - 750 F (370 - 400 C) Fusion