BS EN 60317-49:2000 PDF

Scope: This part of IEC 60317 specifies the requirements of glass-fibre wound resin or varnish impregnated, bare, grade 1 or grade 2 enamelled round copper winding wire, temperature index 180. The impregnating agent can be, for instance, polyester or polyesterimide resin based. NOTE - For this type of wire, the heat shock test is inappropriate and therefore a heat shock temperature cannot be established. Consequently, a class based on the requirements for temperature index and heat shock temperature cannot be specified. The enamelled wire should be based on one of the following standards and should be agreed between purchaser and supplier: IEC 60317-8; IEC 60317-13 or IEC 60317-46. The temperature index of the wire is dependent upon the type of impregnating agent used. The impregnating agent applied to the glass fibre should have a minimum temperature index of 180. The glass-fibre covering may be a) a single layer of glass fibre; b) a double layer of glass fibre, with one layer applied in the direction opposite to that of the other layer. The range of nominal conductor diameters covered by this standard is - for bare covered wires (grade G2): 0,500 mm up to and including 5,000 mm; - for grade 1 enamelled wires (grades 1G1 and 1G2): 0,500 mm up to and including 1,600 mm; - for grade 2 enamelled wires (grades 2G1 and 2G2): 0,500 mm up to and including 5,000 mm. The nominal conductor diameters are specified in clause 4 of the future IEC 60317-0-6.

BS EN 60317-49:2000 history

0000 BS EN 60317-49:2012(2013)
2012 BS EN 60317-49:2012 Specifications for particular types of winding wires. Glass-fibre wound high temperature resin or varnish impregnated, bare or enamelled round copper wire, temperature index 180
2000 BS EN 60317-49:2000 Specifications for particular types of winding wires - Glass-fibre wound resin or varnish impregnated, bare or enamelled round copper wire, temperature index 180