BS EN ISO 15252-1:2000
Plastics - Epoxy powder moulding compounds (EP-PMCs) - Designation system and basis for specifications

Standard No.

BS EN ISO 15252-1:2000

Release Date

2000

Published By

British Standards Institution (BSI)

Latest

BS EN ISO 15252-1:2000

Scope

1 This part of ISO 15252 establishes a data block system for the designation of epoxy powder moulding compounds (EP-PMCs). 2 The various types of EP-PMC are differentiated from each other by a classification system based on information about the filler/reinforcement type and content, the intended method of processing, any special properties and those of the special properties used specifically for designation purposes (designatory properties). 3 This part of ISO 15252 is applicable to all EP-PMCs ready for normal use in the form of powder, granules or ground material. 4 It is not intended to imply that materials having the same designation necessarily give the same performance. This part of ISO 15252 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing. If such additional properties are required, they shall be determined in accordance with the test methods specified in part 2 of this International Standard, if suitable. 5 Whenever general requirement data, as covered by part 3 of this International Standard, need to be indicated, this is also done using this data block system. 6 To ensure that code-letters and code-numbers remain unambiguous, and to avoid conflicts within the system, any new code-letters or code-numbers for use in data block 1, 2 or 3 shall be approved before use by the secretariats of ISO/TC 61/SC 1, SC 12 and SC 13.

BS EN ISO 15252-1:2000 history

• 2000 BS EN ISO 15252-1:2000 Plastics - Epoxy powder moulding compounds (EP-PMCs) - Designation system and basis for specifications