ISO 15252-3:1999 PDF

Scope: This part of ISO 15252 specifies the requirements for the physical and chemical properties of epoxy powder moulding compounds (EP-PMCs) and compression- or injection-moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of general technical and/or economic importance. The properties which are used to characterize the moulding compounds, the test methods and the test conditions are selected from those given in ISO 15252-2. The moulding compounds are divided into types according to their composition and properties. The various types are designated using the designation system defined in ISO 15252-1.

ISO 15252-3:1999 Referenced Document

ISO 15252-1:1999 Plastics - Epoxy powder moulding compounds (EP-PMCs) - Part 1: Designation system and basis for specifications
ISO 15252-2:1999 Plastics - Epoxy powder moulding compounds (EP-PMCs) - Part 2: Preparation of test specimens and determination of properties
ISO 472:1999 Plastics - Vocabulary

1999 ISO 15252-3:1999 Plastics - Epoxy powder moulding compounds (EP-PMCs) - Part 3: Requirements for selected moulding compounds