ISO 603-4:1999
Bonded abrasive products - Dimensions - Part 4: Grinding wheels for surface grinding/peripheral grinding
- Standard No.
- ISO 603-4:1999
- Release Date
- 1999
- Published By
- International Organization for Standardization (ISO)
- Status
- Replace By
- ISO 603-4:1999/cor 1:1999
- Latest
- ISO 603-4:1999/cor 1:1999
- Scope
- This part of ISO 603 specifies the nominal dimensions, in millimeters, of: — Type 1: Straight grinding wheel — Type 5: Wheel recessed on one side — Type 7: Wheel recessed on both sides — Type 20: Wheel relieved on one side — Type 21: Wheel relieved on both sides — Type 22: Wheel relieved on one side and recessed on the other side — Type 23: Wheel relieved and recessed on one side — Type 24: Wheel relieved and recessed on one side and recessed on the other side — Type 25: Wheel relieved and recessed on one side and relieved on the other side — Type 26: Wheel relieved and recessed on both sides. — Type 38: Hubbed wheel — Type 39: Double hubbed wheel These bonded abrasive products are intended to be used for the grinding of plane surfaces where the workpiece is secured to a reciprocating table. The workpiece and the grinding wheel are mechanically guided.
ISO 603-4:1999 history
- 1999 ISO 603-4:1999/cor 1:1999 Bonded abrasive products - Dimensions - Part 4: Grinding wheels for surface grinding/peripheral grinding; Technical Corrigendum 1
- 1999 ISO 603-4:1999 Bonded abrasive products - Dimensions - Part 4: Grinding wheels for surface grinding/peripheral grinding
