DIN EN ISO 5458:1999
Geometrical product specification (GPS) - Geometrical tolerancing - Positional tolerancing (ISO 5458:1998); German version EN ISO 5458:1998
- Standard No.
- DIN EN ISO 5458:1999
- Release Date
- 1999
- Published By
- German Institute for Standardization
- Status
- 2018-11
- Replace By
- DIN EN ISO 5458:2018
- DIN EN ISO 5458 E:2016
- Latest
- DIN EN ISO 5458:2018-11
- Replace
- DIN ISO 5458:1988
- Scope
- This document describes positional tolerancing. This tolerancing method is applied to the location of a point, of a line nominally straight and of a surface nominally plane, e.g. the centre of a sphere, the axis of a hole or shaft and the median surface of a slot. Profile tolerancing is used when lines are not intended to be straight or surfaces are not intended to lie in a plane see ISO 1660.#,,#
DIN EN ISO 5458:1999 history
- 2018 DIN EN ISO 5458:2018-11 Geometrical product specifications (GPS) - Geometrical tolerancing - Pattern and combined geometrical specification (ISO 5458:2018); German version EN ISO 5458:2018
- 2018 DIN EN ISO 5458:2018 Geometrical product specifications (GPS) - Geometrical tolerancing - Pattern and combined geometrical specification (ISO 5458:2018)
- 1999 DIN EN ISO 5458:1999 Geometrical product specification (GPS) - Geometrical tolerancing - Positional tolerancing (ISO 5458:1998); German version EN ISO 5458:1998
- 0000 DIN ISO 5458:1988
