1 This International Standard applies to cold-reduced carbon steel sheet and corresponding hardness requirements. It is suitable for applications where surface is of prime importance.
2 The fabrication limits of cold-reduced carbon steel sheet according to hardness requirements are dependent on the specific range of hardness specified or agreed to. It is produced in thicknesses of 0,36 mm and above (commonly produced up to 3 mm) and in widths of 600 mm and over in coils and cut lengths. The hardness is commonly reported as Rockwell B.
3 The following are common hardness ranges (see 5.6):
CRH-50 Rockwell B 50 to 70
CRH-60 Rockwell B 60 to 75
CRH-70 Rockwell B 70 to 85
CRH Any Rockwell B range of 15 points up to and including HRB 90 maximum (designated minimum
of specified range will be shown)
4 Cold-reduced sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet.
5 This International Standard does not cover commercial quality or drawing qualities (covered in ISO 3574) and cold-reduced carbon steel strip.
ISO 5954:1998 history
2014ISO 5954:2014 Cold-reduced carbon steel sheet according to hardness requirements
2007ISO 5954:2007 Cold-reduced carbon steel sheet according to hardness requirements
1998ISO 5954:1998 Cold-reduced carbon steel sheet according to hardness requirements
1984ISO 5954:1984 Cold-reduced carbon steel sheet to hardness requirements