ASTM B481-68(2019) PDF

Scope: 1.1 This practice describes processes that have been found to be successful in producing adherent electrodeposits of good quality on titanium and certain titanium alloys. Not all of the processes that have been reported as successful are described, but rather three basic ones that have had the widest use. A rather complete listing of the published work on electroplating on titanium is given in the list of references which appear at the end of this practice. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 3.1. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM B481-68(2019) Referenced Document

ASTM B343 Standard Practice for Preparation of Nickel for Electroplating with Nickel*， 2020-11-01 Update

2019 ASTM B481-68(2019) Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating
2013 ASTM B481-68(2013) Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating
1968 ASTM B481-68(2008) Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating
1968 ASTM B481-68(2003)e1 Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating
1997 ASTM B481-68(1997) Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating