ASTM D5702-18(2022) PDF

Scope: 1.1 This practice covers a method to control the removal of samples of coating films from substrates for subsequent laboratory analysis for heavy metal content on a mass basis. This technique can be used in the field, the fabricating shop, or laboratory. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard information, see Section 5, Note 1, and Note 3. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5702-18(2022) Referenced Document

ASTM D4138 Standard Test Methods for Measurement of Dry Film Thickness of Protective Coating Systems by Destructive Means
ASTM D6132 Standard Test Method for Nondestructive Measurement of Dry Film Thickness of Applied Organic Coatings Over Concrete Using an Ultrasonic Gage
ASTM D7091 Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals

2022 ASTM D5702-18(2022) Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals
2018 ASTM D5702-18 Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals
2007 ASTM D5702-07(2012) Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals
2007 ASTM D5702-07 Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals
2002 ASTM D5702-02 Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals
1995 ASTM D5702-95 Standard Practice for Field Sampling of Coating Films for Analysis for Heavy Metals