EN ISO 11202:2009 Acoustics - Noise emitted by machinery and equipment - Measurement of emission sound pressure levels at a work station and at other specified positions - Survey method in situ
General This international Standard specifies a method for measuring the emission sound pressure levels of machinery and equipment@ at a work station and at other specified positions nearby@ in a semi-reverberant field. Emission sound pressure level are measured as A-weighted and@ if required@ C-weighted peak. NOTE 1 The contents of this and related International Standards are summarized in table 1 of ISO 11200:1995. A method is given for determining a local environment correction (subject to a specified limiting maximum value) to be applied to the measured sound pressure levels in order to exclude at least part of the effects of reflections from reflecting surfaces other than the plane on which the machinery or equipment is placed. This correction is based on the equivalent sound absorption area of the test room. A work station is occupied by an operator. It may be located in open space in the room where the source operates@ or in a cab fixed to the source@ or in an enclosure remote from the source. One or more specified positions may be located in the vicinity of an attended or unattended machine. Such positions are sometimes referred to as bystander positions. This International Standard specifies requirements for the survey grade of accuracy on the test environment and instrumentation. Instructions are given for the installation and operation of the machine under test and for the choice of microphone positions for the work station and for other specified positions. The purpose of the measurements is to permit comparison of the performance of different units of a given family of machinery or equipment@ under defined environmental conditions and standardized mounting and operating conditions. The data obtained may also be used for the declaration and verification of emission sound pressure levels as specified in ISO 4871. NOTE 2 At any given position in relation to a particular machine@ and for given mounting and operating conditions@ the emission sound pressure levels determined by the method of this International Standard will in general be lower than the directly measured sound pressure levels for the same machine in the typical workroom where it is used. This is due to reverberation and the contributions of other machines. A method of calculating the sound pressure levels in the vicinity of a machine operating alone in a workroom is given in ISO 11690-3 Commonly observed differences are 1 dB to 5 dB@ but in extreme cases the difference may be even greater.
EN ISO 11202:2009 history
2021EN ISO 11202:2010/A1:2021 Acoustics - Noise emitted by machinery and equipment - Determination of emission sound pressure levels at a work station and at other specified positions applying approximate environmental corrections - Amendment 1 (ISO 11202:2010/Amd 1:2020)
2010EN ISO 11202:2010 Acoustics - Noise emitted by machinery and equipment - Determination of emission sound pressure levels at a work station and at other specified positions applying approximate environmental corrections
2009EN ISO 11202:2009 Acoustics - Noise emitted by machinery and equipment - Measurement of emission sound pressure levels at a work station and at other specified positions - Survey method in situ
1995EN ISO 11202:1995 Acoustics - Noise Emitted by Machinery and Equipment - Measurement of Emission Sound Pressure Levels at a Work Station and at Other Specified Positions - Survey Method in Situ (ISO 11202 : 1995)