ASTM D2752/D2752M-88(2019)
Standard Test Methods for Air Permeability of Asbestos Fibers

Standard No.
ASTM D2752/D2752M-88(2019)
Release Date
2019
Published By
American Society for Testing and Materials (ASTM)
Latest
ASTM D2752/D2752M-88(2019)
Scope
1.1 These test methods cover the measurement of the relative degree of openness or degree of fiberization of milled asbestos fiber by air permeability instruments. 1.2 Method A is the recommended procedure and describes a determination by means of the Rapid Surface Area apparatus. This test method is limited to fibers with an effective surface area in the range from 10 to 250 dm2 /g [490 to 12 000 ft2 /lb]. 1.3 Method B is an alternative procedure and covers the use of the Dyckerhoff apparatus. This test method is limited to fibers within the range from 10 to 600 Dyckerhoff seconds. 1.4 Only those asbestos specimens which are of similar specific gravities will bear strict comparison by these air permeability methods since differences in density result in specimens being tested under different conditions of porosity. 1.5 Samples containing excessive quantities of nonfibrous particles or contaminants will not give reliable or meaningful results. 1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.7 Warning—Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestoscement products, minimize the dust that results. For information on the safe use of chrysotile asbestos, refer to “Safe Use of Chrysotile: A Manual on Preventive and Control Measures.”2 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D2752/D2752M-88(2019) Referenced Document

  • ASTM D2590 Standard Test Method for Sampling Chrysotile Asbestos
  • ASTM D3879 Standard Test Method for Sampling Amphibole Asbestos
  • ASTM E11 Standard Specification for Wire Cloth and Sieves for Testing Purposes
  • ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods

ASTM D2752/D2752M-88(2019) history

Standard Test Methods for Air Permeability of Asbestos Fibers


Copyright ©2024 All Rights Reserved