ASTM D5452-23 PDF

Scope: 1.1 This test method covers the gravimetric determination by filtration of particulate contaminant in a sample of aviation turbine fuel delivered to a laboratory. 1.1.1 The sample is filtered through a test membrane and a control membrane using vacuum. The mass change difference identifies the contaminant level per unit volume. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 4.2, 7.3, 7.5, 11.2, and X1.7.2. Before using this standard, refer to supplier’s safety labels, material safety data sheets, and technical literature. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5452-23 Referenced Document

ASTM D1193 Standard Specification for Reagent Water
ASTM D1535 Standard Practice for Specifying Color by the Munsell System
ASTM D2244 Standard Test Method for Calculation of Color Differences From Instrumentally Measured Color Coordinates
ASTM D2276 Standard Test Method for Particulate Contaminant in Aviation Fuel by Line Sampling
ASTM D3828 Standard Test Methods for Flash Point by Small Scale Closed Tester
ASTM D4306 Standard Practice for Aviation Fuel Sample Containers for Tests Affected by Trace Contamination
ASTM D4865 Standard Guide for Generation and Dissipation of Static Electricity in Petroleum Fuel Systems
ASTM D56 Standard Test Method for Flash Point by Tag Closed Tester
ASTM D6615 Standard Specification for Jet B Wide-Cut Aviation Turbine Fuel
ASTM D8194 Standard Practice for Evaluation of Suitability of 37 mm Filter Monitors and 47 mm Filters Used to Determine Particulate Contaminant in Aviation Turbine Fuels*， 2024-03-01 Update
ASTM D93 Standard Test Methods for Flash-Point by Pensky-Martens Closed Cup Tester

2023 ASTM D5452-23 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration
2020 ASTM D5452-20 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration
2012 ASTM D5452-12 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration
2008 ASTM D5452-08 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration
2006 ASTM D5452-06 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration
2005 ASTM D5452-05 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration
2000 ASTM D5452-00 Standard Test Method for Particulate Contamination in Aviation Fuels by Laboratory Filtration