ASTM E2510-20 PDF

Scope: 1.1 This test method describes the calibration or performance conformance for the torque signal generated by commercial or custom-built rheometers. The specific range of the test depends upon the torque range of the rheometer. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E2510-20 Referenced Document

ASTM E1142 Standard Terminology Relating to Thermophysical Properties
ASTM E4 Standard Practices for Force Verification of Testing Machines
ASTM E473 Standard Terminology Relating to Thermal Analysis
ASTM E617 Standard Specification for Laboratory Weights And Precision Mass Standards

2020 ASTM E2510-20 Standard Test Method for Torque Calibration or Conformance of Rheometers
2007 ASTM E2510-07(2013) Standard Test Method for Torque Calibration or Conformance of Rheometers
2007 ASTM E2510-07 Standard Test Method for Torque Calibration or Conformance of Rheometers