ASTM D705-99(2020) PDF

Scope: 1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in 3.1. 1.2 The values stated in SI units are to be regarded as the standard. NOTE 1—The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding. 1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 2—ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D705-99(2020) Referenced Document

ASTM D149 Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
ASTM D256 Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics*， 2023-03-15 Update
ASTM D3892 Standard Practice for Packaging/Packing of Plastics
ASTM D495 Standard Test Method for High-Voltage, Low-Current, Dry Arc Resistance of Solid Electrical Insulation
ASTM D570 Standard Test Method for Water Absorption of Plastics
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-22 Update
ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
ASTM D956

2020 ASTM D705-99(2020) Standard Specification for Urea-Formaldehyde Molding Compounds
1999 ASTM D705-99(2012) Standard Specification for Urea-Formaldehyde Molding Compounds
1999 ASTM D705-99(2004) Standard Specification for Urea-Formaldehyde Molding Compounds
1999 ASTM D705-99 Standard Specification for Urea-Formaldehyde Molding Compounds