ASTM D7175-05e1 PDF

Scope: 1.1 This test method covers the determination of the dynamic shear modulus and phase angle of asphalt binders when tested in dynamic (oscillatory) shear using parallel plate geometry. It is applicable to asphalt binders having dynamic shear modulus values in the range from 100 Pa to 10 MPa. This range in modulus is typically obtained between 4 and 88°C at 10 rad/s. This test method is intended for determining the linear viscoelastic properties of asphalt binders as required for specification testing and is not intended as a comprehensive procedure for the full characterization of the viscoelastic properties of asphalt binders. 1.2 This standard is appropriate for unaged materials, material aged in accordance with Test Method D 2872, material aged in accordance with Practice D 6521, or material aged in accordance with both Test Method D 2872 and Practice D 6521. 1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D7175-05e1 Referenced Document

ASTM C670 Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials
ASTM D140 Standard Practice for Sampling Bituminous Materials*， 2024-04-22 Update
ASTM D2170 Standard Test Method for Kinematic Viscosity of Asphalts (Bitumens)
ASTM D2171 Standard Test Method for Viscosity of Asphalts by Vacuum Capillary Viscometer
ASTM D2872 Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt (Rolling Thin-Film Oven Test)
ASTM D6373 Standard Specification for Performance Graded Asphalt Binder
ASTM D6521 Standard Practice for Accelerated Aging of Asphalt Binder Using a Pressurized Aging Vessel (PAV)*， 2022-05-01 Update
ASTM E563 Standard Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature
ASTM E644 Standard Test Methods for Testing Industrial Resistance Thermometers
ASTM E77 Standard Test Method for Inspection and Verification of Thermometers
ASTM E882 Standard Guide for Accountability and Quality Control in the Chemical Analysis Laboratory

2024 ASTM D7175-23 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer
2015 ASTM D7175-15 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer
2008 ASTM D7175-08 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer
2007 ASTM D7175-07 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer
2005 ASTM D7175-05e1 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer
2005 ASTM D7175-05 Standard Test Method for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer