This document specifies the requirements, test methods and inspection rules for ultrasonic sensor assemblies for automobiles. This document is applicable to the ultrasonic sensor assembly (hereinafter referred to as assembly) used in automobiles.
GB/T 41484-2022 Referenced Document
GB 34660-2017 Road vehicles—Requirements and test methods of electromagnetic compatibility
GB/T 18655-2018 Vehicles, boats and internal combustion engines—Radio disturbance characteristics—Limits and methods of measurement for the protection of on-board receivers
GB/T 19951-2019 Road vehicles—Disturbances test methods for electrical/electronic component from electrostatic discharge
GB/T 21437.2-2021 Road vehicles—Test method of electrical disturbances from conduction and coupling—Part 2: Electrical transient conduction along supply lines only
GB/T 21437.3-2021 Road vehicles—Test method of electrical disturbances from conduction and coupling—Part 3: Electrical transient transmission by capacitive and inductive coupling via lines other than supply lines
GB/T 28046.2-2019 Road vehicles—Environmental conditions and testing for electrical and electronic equipment—Part 2: Electrical loads
GB/T 28046.3-2011 Road vehicles.Environmental conditions and testing for electrical and electronic equipment.Part 3:Mechanical loads
GB/T 28046.4-2011 Road vehicles.Environmental conditions and testing for electrical and electronic equipment.Part 4: Climatic loads
GB/T 28046.5-2013 Road vehicles.Environmental conditions and testing for electrical and electronic equipment.Part 5: Chemical loads
GB/T 2828.1 Inspection procedure by count sampling part 1: Lot by lot inspection sampling plan retrieved by acceptance quality limit (AQL)
GB/T 30038-2013 Road vehicles.Degrees of electrical equipment protection (IP-Code)
ISO 11124-2:2018 Preparation of steel substrates before application of paints and related products - Specifications for metallic blast-cleaning abrasives - Part 2: Chilled-iron grit
ISO 20567-1 Paints and varnishes - Determination of stone-chip resistance of coatings - Part 1: Multi-impact testing
ISO 4892-2:2013 Plastics - Methods of exposure to laboratory light sources - Part 2: Xenon-arc lamps