ASTM D8316-20a PDF

Scope: 1.1 This test method covers an extreme pressure (EP) lubricating oil’s coefficient of friction and its ability to protect against wear when subjected to high-frequency, linear oscillation motion. The test utilizes a roller-on-disc geometry, where the roller is inclined/deflected by 10° to the oscillating movement. The procedure is identical to that described in DIN 51834, Part 4. 1.2 This test method can also be used to determine the ability of a non-EP lubricating oil to protect against wear and its coefficient of friction under similar test conditions. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8316-20a Referenced Document

ASTM A295 Standard Specification for High-Carbon Anti-Friction Bearing Steel
ASTM D235 Standard Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)
ASTM D5182 Standard Test Method for Evaluating the Scuffing Load Capacity of Oils (FZG Visual Method)
ASTM D5706 Standard Test Method for Determining Extreme Pressure Properties of Lubricating Greases Using A High-Frequency, Linear-Oscillation (SRV) Test Machine
ASTM D6425 Standard Test Method for Measuring Friction and Wear Properties of Extreme Pressure (EP) Lubricating Oils Using SRV Test Machine
ASTM D7421 Standard Test Method for Determining Extreme Pressure Properties of Lubricating Oils Using High-Frequency, Linear-Oscillation (SRV) Test Machine
ASTM E45 Standard Test Methods for Determining the Inclusion Content of Steel
ASTM G40 Standard Terminology Relating to Wear and Erosion

2020 ASTM D8316-20a Standard Test Method for Measuring Friction and Wear Properties of Extreme Pressure (EP) Lubricating Oils with the Roller-Disk Geometry Using SRV Test Machine
2020 ASTM D8316-20 Standard Test Method for Measuring Friction and Wear Properties of Extreme Pressure (EP) Lubricating Oils with the Roller-Disk Geometry Using SRV Test Machine