ASTM D5485-16
Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- Standard No.
- ASTM D5485-16
- Release Date
- 2016
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D5485-21
- Latest
- ASTM D5485-21
- Scope
- 1.1 This fire-test-response standard measures the corrosive effect by loss of metal from the combustion products of materials, components, or products. 1.2 This test method provides corrosion results of product and material specimens limited to a maximum size of 100 by 100 mm in area and 50 mm thick. 1.3 Additional information regarding the targets, the test conditions, and test limitations is provided in the annex. 1.4 The results of this test method have not been investigated with respect to correlation to actual fires. 1.5 An ISO standard exists, as developed by ISO TC 61 (Plastics), subcommittee 4 (on burning behavior), which is technically very similar to this test method and is designated ISO 11907-4. 1.6 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See SI10) 1.7 This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions. 1.8 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests. 1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
ASTM D5485-16 Referenced Document
- ASTM D1711 Standard Terminology Relating to Electrical Insulation
- ASTM D6113 Standard Test Method for Using a Cone Calorimeter to Determine Fire-Test Response Characteristics of Insulating Materials Contained in Electrical or Optical Fiber Cables
- ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
- ASTM E1354 Standard Test Method for Heat and Visible Smoke Release Rates for Materials and Products Using an Oxygen Consumption Calorimeter
- ASTM E176 Standard Terminology of Fire Standards
- IEEE/ASTM SI 10 American National Standard for Metric Practice
- ISO 11907-4 Plastics - Smoke generation - Determination of the corrosivity of fire effluents - Part 4: Dynamic decomposition method using a conical radiant heater
ASTM D5485-16 history
- 2021 ASTM D5485-21 Standard Test Method for Determining Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- 2016 ASTM D5485-16 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- 2011 ASTM D5485-11 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- 2010 ASTM D5485-10 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- 2009 ASTM D5485-09 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- 2005 ASTM D5485-05 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
- 1999 ASTM D5485-99 Standard Test Method for Determining the Corrosive Effect of Combustion Products Using the Cone Corrosimeter
