ASTM C341/C341M-18 PDF

Scope: 1.1 This practice covers the procedures for the preparation and conditioning of cast, drilled, or sawed specimens of hydraulic-cement mortar and concrete for length change due to causes other than externally applied forces. It can be readily adapted, if desired, to studies of length change involving alternative schedules or environmental treatments. 1.2 The values stated in either inch-pound units or SI units shall be regarded separately as standard. The units stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining in any way. The inch-pound units are shown in brackets. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C341/C341M-18 Referenced Document

ASTM A276/A276M Standard Specification for Stainless Steel Bars and Shapes*， 2024-02-01 Update
ASTM C125 Standard Terminology Relating to Concrete and Concrete Aggregates*， 2021-10-01 Update
ASTM C157/C157M Standard Test Method for Length Change of Hardened Hydraulic-Cement, Mortar, and Concrete
ASTM C192/C192M Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory*， 2019-12-01 Update
ASTM C31/C31M Standard Practice for Making and Curing Concrete Test Specimens in the Field*， 2024-04-01 Update
ASTM C42/C42M Standard Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete
ASTM C490/C490M Standard Practice for Use of Apparatus for the Determination of Length Change of Hardened Cement Paste, Mortar, and Concrete*， 2021-12-01 Update
ASTM C666/C666M Standard Test Method for Resistance of Concrete to Rapid Freezing and Thawing*， 2024-04-22 Update

2018 ASTM C341/C341M-18 Standard Practice for Preparation and Conditioning of Cast, Drilled, or Sawed Specimens of Hydraulic-Cement Mortar and Concrete Used for Length Change Measurements
2013 ASTM C341/C341M-13 Standard Practice for Preparation and Conditioning of Cast, Drilled, or Sawed Specimens of Hydraulic-Cement Mortar and Concrete Used for Length Change Measurements
2006 ASTM C341/C341M-06 Standard Practice for Length Change of Cast, Drilled, or Sawed Specimens of Hydraulic-Cement Mortar and Concrete
2005 ASTM C341/C341M-05 Standard Practice for Length Change of Cast, Drilled, or Sawed Specimens of Hydraulic-Cement Mortar and Concrete
2003 ASTM C341/C341M-03a Standard Practice for Length Change of Cast, Drilled, or Sawed Specimens of Hydraulic-Cement Mortar and Concrete
2003 ASTM C341/C341M-03 Standard Practice for Length Change of Cast, Drilled, or Sawed Specimens of Hydraulic-Cement Mortar and Concrete
1996 ASTM C341-96 Standard Test Method for Length Change of Drilled or Sawed Specimens of Hydraulic-Cement Mortar and Concrete