ASTM A905-19 PDF

Scope: 1.1 This specification covers requirements for a high strength drawn and cold rolled steel wire in two strength classes, with rectangular cross section, and round mill edge. This wire is intended for prestressed vessel and press frame windings. 1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standards. Within the text and tables, the SI units are shown in parentheses. The values stated in each system are not exact equivalents. Therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A905-19 Referenced Document

ASTM A370 Standard Test Methods and Definitions for Mechanical Testing of Steel Products
ASTM A510/A510M Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel*， 2024-04-22 Update
ASTM A700 Standard Practices for Packaging, Marking, and Loading Methods for Steel Products for Domestic Shipment
ASTM A751 Standard Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
ASTM E309 Standard Practice for Eddy-Current Examination of Steel Tubular Products Using Magnetic Saturation

2019 ASTM A905-19 Standard Specification for Steel Wire, Pressure Vessel Winding
2004 ASTM A905-04(2017) Standard Specification for Steel Wire, Pressure Vessel Winding
2004 ASTM A905-04(2010) Standard Specification for Steel Wire, Pressure Vessel Winding
2004 ASTM A905-04 Standard Specification for Steel Wire, Pressure Vessel Winding
1993 ASTM A905-93(1998) Standard Specification for Steel Wire, Pressure Vessel Winding