ASTM B335-03(2018)
Standard Specification for Nickel-Molybdenum Alloy Rod

Standard No.
ASTM B335-03(2018)
Release Date
2018
Published By
American Society for Testing and Materials (ASTM)
Latest
ASTM B335-03(2018)
Scope
1.1 This specification2 covers rod of nickel-molybdenum alloys (UNS N10001, N10665, N10675, N10629, and N10624)3 as shown in Table 1, for use in general corrosive service. 1.2 The following products are covered under this specification: 1.2.1 Rods 5⁄16 to 3⁄4 in. (7.94 to 19.05 mm) excl in diameter, hot or cold finished, solution annealed and pickled or mechanically descaled. 1.2.2 Rods 3⁄4 to 31⁄2 in. (19.05 to 88.9 mm) incl in diameter, hot or cold finished, solution annealed, ground or turned. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM B335-03(2018) Referenced Document

  • ASTM B880 Standard Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys, and Cobalt Alloys
  • ASTM E1473 Standard Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys
  • ASTM E29 Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
  • ASTM E55 Standard Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition
  • ASTM E8/E8M Standard Test Methods for Tension Testing of Metallic Materials*， 2024-01-01 Update

ASTM B335-03(2018) history

Standard Specification for Nickel-Molybdenum Alloy Rod


Copyright ©2024 All Rights Reserved