ASTM E2254-18
Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- Standard No.
- ASTM E2254-18
- Release Date
- 2018
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM E2254-23
- Latest
- ASTM E2254-24
- Scope
- 1.1 This test method describes the calibration or performance confirmation for the storage modulus scale of a commercial or custom built dynamic mechanical analyzer (DMA) over the temperature range of –100 °C to 300 °C using reference materials in the range of 1 GPa to 200 GPa. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM E2254-18 Referenced Document
- ASTM D638 Standard Test Method for Tensile Properties of Plastics
- ASTM E1142 Standard Terminology Relating to Thermophysical Properties
- ASTM E2425 Standard Test Method for Loss Modulus Conformance of Dynamic Mechanical Analyzers*， 2021-10-01 Update
- ASTM E473 Standard Terminology Relating to Thermal Analysis
- ASTM E698 Standard Test Method for Arrhenius Kinetic Constants for Thermally Unstable Materials
ASTM E2254-18 history
- 2024 ASTM E2254-24 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2023 ASTM E2254-23 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2018 ASTM E2254-18 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2013 ASTM E2254-13 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2011 ASTM E2254-11 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2009 ASTM E2254-09 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2008 ASTM E2254-08 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
- 2003 ASTM E2254-03 Standard Test Method for Storage Modulus Calibration of Dynamic Mechanical Analyzers
