ASTM E604-18 PDF

Scope: 1.1 This test method covers the dynamic tear (DT) test using specimens that are 3⁄16 in. to 5⁄8 in. (5 mm to 16 mm) inclusive in thickness. 1.2 This test method is applicable to materials with a minimum thickness of 3⁄16 in. (5 mm). 1.3 The pressed-knife procedure described for sharpening the notch tip generally limits this test method to materials with a hardness level less than 36 HRC. NOTE 1—The designation 36 HRC is a Rockwell hardness number of 36 on Rockwell C scale as defined in Test Methods E18. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E604-18 Referenced Document

ASTM B221 Standard Specification for Aluminum-Alloy Extruded Bars, Rods, Wire, Shapes, and Tubes
ASTM E18 Standard Test Methods for Rockwell Hardness of Metallic Materials*， 2022-05-01 Update
ASTM E399 Standard Test Method for Plane-Strain Fracture Toughness of Metallic Materials
ASTM E6 Standard Terminology Relating to Methods of Mechanical Testing

2018 ASTM E604-18 Standard Test Method for Dynamic Tear Testing of Metallic Materials
2015 ASTM E604-15 Standard Test Method for Dynamic Tear Testing of Metallic Materials
1983 ASTM E604-83(2008) Standard Test Method for Dynamic Tear Testing of Metallic Materials
1983 ASTM E604-83(2002) Standard Test Method for Dynamic Tear Testing of Metallic Materials
1994 ASTM E604-83(1994) Standard Test Method for Dynamic Tear Testing of Metallic Materials
1983 ASTM E604-83 Standard Test Method for Dynamic Tear Testing of Metallic Materials