This document specifies the direct inspection and indirect inspection methods of the Brinell hardness tester (hereinafter referred to as the hardness tester) used to determine the Brinell hardness according to GB/T231.1, and specifies the inspection cycle for the two methods of inspection of the hardness tester. The direct inspection includes checking whether the performance parameters of the tested hardness tester are within the specified limits, while the indirect inspection uses the standard hardness block calibrated according to GB/T231.3 for hardness measurement to check the comprehensive performance of the hardness tester. If the hardness tester is also used for hardness testing by other methods, it is necessary to test the hardness tester separately according to each method. This document applies to both permanently installed hardness testers and portable hardness testers. For durometers that cannot comply with the specified force/time configuration, Appendix B gives a direct inspection procedure for the modification of the force and test cycle time of the durometer.
GB/T 231.2-2022 Referenced Document
GB/T 13634 Metallic materials—Calibration of force-proving instruments used for the verification of uniaxial testing machines
GB/T 231.1 Metallic materials—Brinell hardness test—Part 1: Test method
GB/T 231.3 Metallic materials—Brinell hardness test—Part 3:Calibration of reference blocks