ASTM D4527-18 PDF

Scope: 1.1 This test method covers the procedure for measuring carbon black solvent extractables. 1.1.1 This test method determines the total material extracted from carbon black by toluene under specified conditions. The procedure is also applicable to other solvents such as cyclohexane, etc. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Section 7. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D4527-18 Referenced Document

ASTM D4483 Standard Practice for Determining Precision for Test Method Standards in the Rubber and Carbon Black Industries

2023 ASTM D4527-18(2023) Standard Test Method for Carbon Black—Solvent Extractables
2018 ASTM D4527-18 Standard Test Method for Carbon Black—Solvent Extractables
2016 ASTM D4527-99(2016) Standard Test Method for Carbon Black&x2014;Solvent Extractables
2011 ASTM D4527-99(2011) Standard Test Method for Carbon BlackSolvent Extractables
1999 ASTM D4527-99(2004) Standard Test Methods for Carbon Black8212;Solvent Extractables
1999 ASTM D4527-99 Standard Test Methods for Carbon Black-Solvent Extractables