ASTM D3910-21 PDF

Scope: 1.1 These practices cover the design, testing, and construction of mixtures for surface treatment of pavements. It is written as a guide and should be used as such. End-use specifications should be adapted to conform to job and user requirements. 1.2 The values stated in SI units are to be regarded as the standard. The non-SI units used in this standard are allowed by the subcommittee for clarification in the use of the standard. 1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3910-21 Referenced Document

ASTM C128 Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate
ASTM D1073 Standard Specification for Fine Aggregate for Bituminous Paving Mixtures
ASTM D2397/D2397M Standard Specification for Cationic Emulsified Asphalt
ASTM D2419 Standard Test Method for Sand Equivalent Value of Soils and Fine Aggregate
ASTM D242/D242M Standard Specification for Mineral Filler for Asphalt Mixtures
ASTM D3666 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials*， 2024-04-21 Update
ASTM D8 Standard Terminology Relating to Materials for Roads and Pavements
ASTM D977 Standard Specification for Emulsified Asphalt

2021 ASTM D3910-21 Standard Practices for Design, Testing, and Construction of Slurry Seal
2015 ASTM D3910-15 Standard Practices for Design, Testing, and Construction of Slurry Seal
2011 ASTM D3910-11 Standard Practices for Design, Testing, and Construction of Slurry Seal
2007 ASTM D3910-07 Standard Practices for Design, Testing, and Construction of Slurry Seal
1998 ASTM D3910-98(2004) Standard Practices for Design, Testing, and Construction of Slurry Seal
1998 ASTM D3910-98 Standard Practices for Design, Testing, and Construction of Slurry Seal