ASTM E1703/E1703M-10(2023) PDF

Scope: 1.1 This test method describes the procedure for the measurement of the depth of the rut at a chosen location in a pavement surface using a straightedge and a gauge. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E1703/E1703M-10(2023) Referenced Document

ASTM E2133 Standard Test Method for Using a Rolling Inclinometer to Measure Longitudinal and Transverse Profiles of a Traveled Surface
ASTM E867 Terminology Relating to Vehicle-Pavement Systems

2023 ASTM E1703/E1703M-10(2023) Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge
2010 ASTM E1703/E1703M-10(2015) Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge
2010 ASTM E1703/E1703M-10 Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge
1995 ASTM E1703/E1703M-95(2005) Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge
1995 ASTM E1703/E1703M-95(2000) Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge