ISO 16063-34:2019
Methods for the calibration of vibration and shock transducers — Part 34: Testing of sensitivity at fixed temperatures

Standard No.

ISO 16063-34:2019

Release Date

2019

Published By

International Organization for Standardization (ISO)

Latest

ISO 16063-34:2019

Scope

This document details specifications for the instrumentation and methods to be used for testing fixed temperature sensitivity of vibration transducers. It applies to rectilinear velocity and acceleration transducers. The methods specified use both a comparison to a reference transducer and an absolute measurement by laser interferometer. This document is applicable for a frequency range from 10 Hz to 3 kHz (method-dependent), a dynamic range from 1 m/s2 to 100 m/s2 (frequency-dependent) and a temperature range from –190 °C to 800 °C (method-dependent). Although it is possible to achieve these ranges among all the described systems, generally each has limitations within them. Method 1 (using a laser interferometer) is applicable to magnitude of sensitivity and phase calibration in the frequency range 10 Hz to 3 kHz at fixed temperatures (see Clause 7). Method 2 (using a reference transducer inside a chamber whose temperature limit is –70 °C to 500 °C) can be used for magnitude of sensitivity and phase calibration in the frequency range 10 Hz to 1 kHz at fixed temperatures (see Clause 8). Method 3 (using a reference transducer outside the chamber) can only be used for the determination of the temperature response of complex sensitivity over a certain temperature range (see Clause 9). NOTE Method 1 and Method 2 can provide the deviation of complex sensitivity over a certain temperature range if the calibration is also done at the reference temperature (room temperature 23 °C ± 5 °C). To ensure the consistency of the use and test condition, the transducer, its cable and the conditioning amplifier are intended to be considered as a single unit and tested together.

ISO 16063-34:2019 Referenced Document

• ISO 16063-11:1999 Methods for the calibration of vibration and shock transducers - Part 11: Primary vibration calibration by laser interferometry
• ISO 16063-21:2003 Methods for the calibration of vibration and shock transducers - Part 21: Vibration calibration by comparison with a reference transducer
• ISO 2041 Mechanical vibration, shock and condition monitoring - Vocabulary

ISO 16063-34:2019 history

• 2019 ISO 16063-34:2019 Methods for the calibration of vibration and shock transducers — Part 34: Testing of sensitivity at fixed temperatures