ASTM D197-19 PDF

Scope: 1.1 This test method covers the determination of the fineness by sieve analysis of coal sampled from a dry pulverizing operation. It is not applicable to products of wet milling or to fines that have clustered into an agglomerated mass. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D197-19 Referenced Document

2019 ASTM D197-19 Standard Test Method for Sampling and Fineness Test of Pulverized Coal
1987 ASTM D197-87(2012) Standard Test Method for Sampling and Fineness Test of Pulverized Coal
1987 ASTM D197-87(2007) Standard Test Method for Sampling and Fineness Test of Pulverized Coal
1987 ASTM D197-87(2002) Standard Test Method for Sampling and Fineness Test of Pulverized Coal
1994 ASTM D197-87(1994)e1 Standard Test Method for Sampling and Fineness Test of Pulverized Coal