ASTM D5140-95
Standard Guide for Testing Polyurethane "Poured in Place" Thermal Break Materials

Standard No.

ASTM D5140-95

Release Date

1995

Published By

American Society for Testing and Materials (ASTM)

Status

Withdraw 2004-01

Latest

ASTM D5140-95

Scope

1.1 This guide covers the preparation of a standard-size test sample and basic tests for physical property determinations of solid thermal break materials. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. NOTE 1—There is no similar or equivalent ISO standard. 1.3 The following precautionary caveat pertains only to the test method portion, Sections 6 and 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5140-95 Referenced Document

• ASTM C1045 Standard Practice for Calculating Thermal Transmission Properties Under Steady-State Conditions*， 1997-04-21 Update
• ASTM C177 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus*， 1997-04-21 Update
• ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus*， 1998-04-21 Update
• ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics*， 1999-04-21 Update
• ASTM D1622 Standard Test Method for Apparent Density of Rigid Cellular Plastics*， 1998-04-21 Update
• ASTM D2240 Standard Test Method for Properties of Rubber &8212; Durometer Hardness*， 2024-04-21 Update
• ASTM D256 Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics*， 2023-03-15 Update
• ASTM D297 Standard Test Methods for Rubber Products-Chemical Analysis
• ASTM D638M *， 1996-01-01 Update
• ASTM D696 Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between -30176C and 30176C With a Vitreous Silica Dilatometer*， 1998-04-21 Update
• ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-21 Update
• ASTM D792 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement*， 1998-04-21 Update
• ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
• ASTM E228 Standard Test Method for Linear Thermal Expansion of Solid Materials With a Vitreous Silica Dilatometer *， 1995-04-21 Update

ASTM D5140-95 history

• 1995 ASTM D5140-95 Standard Guide for Testing Polyurethane "Poured in Place" Thermal Break Materials