1.1 This specification covers four different grades of round and shaped plain carbon and alloy steel spring wire, uniform in quality and temper, intended for the manufacture of mechanical springs that can withstand moderate fatigue stresses over some relatively low number of cycles. The quality level is between the commercial quality grades of wire such as Specifications A401/A401M , A231/A231M , and A229/A229M and the valve spring quality grades such Specifications as A230/A230M , A232/A232M , and A877/A877M . It is similar to the grade TD (referenced in EN 10270-2) intended for medium fatigue levels, such as required for clutch springs. This wire shall be either in the annealed and cold-drawn or quenched and tempered condition as specified by purchaser. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM A1000/A1000M-17(2023) history
2023ASTM A1000/A1000M-17(2023) Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality
2017ASTM A1000/A1000M-17 Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality
2011ASTM A1000/A1000M-11 Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality
2005ASTM A1000-05 Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality
1999ASTM A1000-99 Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality