API MPMS 9.1-2012 Manual of Petroleum Measurement Standards Chapter 9.1 - Standard Test Method for Density@ Relative Density@ or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method (Third Edition)
This test method covers the laboratory determination using a glass hydrometer in conjunction with a series of calculations@ of the density@ relative density@ or API gravity of crude petroleum@ petroleum products@ or mixtures of petroleum and nonpetroleum products normally handled as liquids@ and having a Reid vapor pressure of 101.325 kPa (14.696 psi) or less. Values are determined at existing temperatures and corrected to 15??or 60??by means of a series of calculations and international standard tables. The initial hydrometer readings obtained are uncorrected hydrometer readings and not density measurements. Readings are measured on a hydrometer at either the reference temperature or at another convenient temperature@ and readings are corrected for the meniscus effect@ the thermal glass expansion effect@ alternate calibration temperature effects and to the reference temperature by means of the Petroleum Measurement Tables; values obtained at other than the reference temperature being hydrometer readings and not density measurements. Readings determined as density@ relative density@ or API gravity can be converted to equivalent values in the other units or alternate reference temperatures by means of Interconversion Procedures (API MPMS Chapter 11.5)@ or Adjunct to D1250 Guide for Petroleum Measurement Tables (API MPMS Chapter 11.1)@ or both@ or tables@ as applicable. The initial hydrometer readings determined in the laboratory shall be recorded before performing any calculations. The calculations required in Section 10 shall be applied to the initial hydrometer reading with observations and results reported as required by Section 11 prior to use in a subsequent calculation procedure (ticket calculation@ meter factor calculation@ or base prover volume determination). Annex A1 contains a procedure for verifying or certifying the equipment for this test method. The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only. This standard does not purport to address all of the safety concerns@ if any@ associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. *A Summary of Changes section appears at the end of this standard
API MPMS 9.1-2012 history
2012API MPMS 9.1-2012 Manual of Petroleum Measurement Standards Chapter 9.1 - Standard Test Method for Density@ Relative Density@ or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method (Third Edition)
2002API MPMS 9.1-2002 Manual of Petroleum Measurement Standards Chapter 9 - Density Determination Section 1 - Standard Test Method for Density@ Relative Density (Specific Gravity)@ or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method (Second Edi
1981API MPMS 9.1-1981 Manual of Petroleum Measurement Standards Chapter 9 - Density Determination Section 1 - Hydrometer Test Method for Density@ Relative Density (Specific Gravity)@ or API Gravity of Crude Petroleum and Liquid Petroleum Products (ASTM D1298)(R 1992)