ASTM D5324-16
Standard Guide for Testing Water-Borne Architectural Coatings

Standard No.

ASTM D5324-16

Release Date

2016

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5324-16(2022)

Latest

ASTM D5324-16(2022)

Scope

1.1 This guide covers the selection and use of procedures for testing water-borne coatings to be used on exterior, interior or both types of surfaces (Note 1). The properties that can be examined or, in some cases, the relevant test procedures are listed in Table 1 and Table 2. NOTE 1—The term “architectural coating” as used here combines the definition in Terminology D16 with that in the FSCT Paint/Coatings Dictionary, 2 as follows: “Organic coatings intended for on-site application to interior or exterior surfaces of residential, commercial, institutional, or industrial buildings, in contrast to industrial coatings. They are protective and decorative finishes applied at ambient temperatures. Often called Trade Sales Coatings.” NOTE 2—Architectural coatings that are designed to give better performance than most conventional coatings because they are tougher and more stain and abrasion resistant are covered by Guide D3730. 1.2 The types of organic coatings covered by this guide are as follows: (1) Type 1 Interior Latex Flat Wall Paints, (2) Type 2 Exterior Latex House Paints, (3) Type 3 Water-Borne Floor Paints, and (4) Type 4 Interior Latex Semigloss and Gloss Paints. 1.2.1 Each is intended for application by brushing, rolling, spraying or other means to the material appropriate for its type, which may include plaster, masonry, wallboard, wood, steel, previously painted surfaces, and other architectural substrates. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5324-16 Referenced Document

• ASTM D1006 Standard Practice for Conducting Exterior Exposure Tests of Paints on Wood
• ASTM D1014 Standard Practice for Conducting Exterior Exposure Tests of Paints on Steel
• ASTM D1210 Standard Test Method for Fineness of Dispersion of Pigment-Vehicle Systems by Hegman-Type Gage
• ASTM D1296 Standard Test Method for Odor of Volatile Solvents and Diluents
• ASTM D1308 Standard Test Method for Effect of Household Chemicals on Clear and Pigmented Organic Finishes
• ASTM D1475 Standard Test Method For Density of Liquid Coatings, Inks, and Related Products
• ASTM D1554 Standard Terminology Relating to Wood-Base Fiber and Particle Panel Materials*， 2023-08-04 Update
• ASTM D16 Standard Terminology for Paint, Related Coatings, Materials, and Applications
• ASTM D1640 Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings at Room Temperature
• ASTM D1729 Standard Practice for Visual Appraisal of Colors and Color Differences of Diffusely-Illuminated Opaque Materials
• ASTM D1849 Standard Test Method for Package Stability of Paint*， 2019-04-01 Update
• ASTM D185 Standard Test Methods for Coarse Particles in Pigments, Pastes, and Paints
• ASTM D2064 Standard Test Method for Print Resistance of Architectural Paints
• ASTM D215 Standard Practice for the Chemical Analysis of White Linseed Oil Paints
• ASTM D2196 Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational (Brookfield type) Viscometer
• ASTM D2197 Standard Test Method for Adhesion of Organic Coatings by Scrape Adhesion
• ASTM D2243 Standard Test Method for Freeze-Thaw Resistance of Water-Borne Coatings
• ASTM D2244 Standard Test Method for Calculation of Color Differences From Instrumentally Measured Color Coordinates
• ASTM D2369 Standard Test Method for Volatile Content of Coatings
• ASTM D2370 Standard Test Method for Tensile Properties of Organic Coatings
• ASTM D2486 Standard Test Methods for Scrub Resistance of Wall Paints*， 2024-04-21 Update
• ASTM D2574 Standard Test Method for Resistance of Emulsion Paints in the Container to Attack by Microorganisms*， 2020-08-01 Update
• ASTM D2805 Standard Test Method for Hiding Power of Paints by Reflectometry
• ASTM D3168 Standard Practice for Qualitative Identification of Polymers in Emulsion Paints*， 2022-12-01 Update
• ASTM D3258 Standard Test Method for Porosity of White or Near White Paint Films by Staining*， 2019-04-01 Update
• ASTM D3273 Standard Test Method for Resistance to Growth of Moid on the Surface of Interior Coatings in an Enviormental Chamber
• ASTM D3359 Standard Test Methods for Measuring Adhesion by Tape Test
• ASTM D344 Standard Test Method for Relative Hiding Power of Paints by the Visual Evaluation of Brushouts
• ASTM D3450 Standard Test Method for Washability Properties of Interior Architectural Coatings*， 2020-12-01 Update
• ASTM D3456 Standard Practice for Determining by Exterior Exposure Tests the Susceptibility of Paint Films to Microbiological Attack
• ASTM D358 Standard Specification for Wood to Be Used as Panels in Weathering Tests of Coatings
• ASTM D3719 Standard Test Method for Quantifying Dirt Collection on Coated Exterior Panels
• ASTM D3723 Standard Test Method for Pigment Content of Water-Emulsion Paints by Low-Temperature Ashing
• ASTM D3730 Standard Guide for Testing High-Performance Interior Architectural Wall Coatings
• ASTM D3792 Standard Test Method for Water Content of Coatings by Direct Injection Into a Gas Chromatograph
• ASTM D3793 Standard Test Method for Low-Temperature Coalescence of Latex Paint Films by Porosity Measurement *， 2024-04-21 Update
• ASTM D3925 Standard Practice for Sampling Liquid Paints and Related Pigmented Coatings
• ASTM D3928 Standard Test Method for Evaluation of Gloss or Sheen Uniformity
• ASTM D3960 Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings
• ASTM D4017 Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method
• ASTM D4060 Standard Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser
• ASTM D4062 Standard Test Method for Leveling of Paints by Draw-Down Method
• ASTM D4213 Standard Test Method for Scrub Resistance of Paints by Abrasion Weight Loss
• ASTM D4214 Standard Test Methods for Evaluating the Degree of Chalking of Exterior Paint Films
• ASTM D4287 Standard Test Method for High-Shear Viscosity Using a Cone/Plate Viscometer
• ASTM D4400 Standard Test Method for Sag Resistance of Paints Using a Multinotch Applicator
• ASTM D4585 Standard Practice for Testing Water Resistance of Coatings Using Controlled Condensation
• ASTM D4707 Standard Test Method for Measuring Paint Spatter Resistance During Roller Application
• ASTM D4828 Standard Test Methods for Practical Washability of Organic Coatings*， 2020-12-01 Update
• ASTM D4946 Standard Test Method for Blocking Resistance of Architectural Paints*， 2017-02-01 Update
• ASTM D4958 Standard Test Method for Comparison of the Brush Drag of Latex Paints
• ASTM D5007 Standard Test Method for Wet-to-Dry Hiding Change*， 2017-06-01 Update
• ASTM D5068 Standard Practice for Preparation of Paint Brushes for Evaluation
• ASTM D5069 Standard Practice for Preparation of Paint-Roller Covers for Evaluation
• ASTM D5150 Standard Test Method for Hiding Power of Architectural Paints Applied by Roller*， 2017-06-01 Update
• ASTM D5179 Standard Test Method for Measuring Adhesion of Organic Coatings to Plastic Substrates by Direct Tensile Testing
• ASTM D522 Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings
• ASTM D523 Standard Test Method for Specular Gloss
• ASTM D5326 Standard Test Method for Color Development in Tinted Latex Paints
• ASTM D562 Standard Test Method for Consistency of Paints Measuring Krebs Unit (KU) Visosity Using a Stormer-Type Viscometer
• ASTM D5895 Standard Test Methods for Measuring Times of Drying or Curing During Film Formation of Organic Coatings Using Mechanical Recorders
• ASTM D6037 Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings
• ASTM D6583 Standard Test Method for Porosity of Paint Film by Mineral Oil Absorption*， 2019-04-01 Update
• ASTM D660 Standard Test Method for Evaluating Degree of Checking of Exterior Paints*， 2019-10-01 Update
• ASTM D661 Standard Test Method for Evaluating Degree of Cracking of Exterior Paints*， 2019-10-01 Update
• ASTM D662 Standard Test Method for Evaluating Degree of Erosion of Exterior Paints*， 2019-10-01 Update
• ASTM D6686 Standard Test Method for Evaluation of Tannin Stain Resistance of Coatings*， 2019-04-01 Update
• ASTM D6736 Standard Test Method for Burnish Resistance of Latex Paints*， 2019-04-01 Update
• ASTM D6900 Standard Test Method for Wet Adhesion of Latex Paints to a Gloss Alkyd Enamel Substrate*， 2020-12-01 Update
• ASTM D7072 Standard Practice for Evaluating Accelerated Efflorescence of Latex Coatings*， 2019-04-01 Update
• ASTM D7190 Standard Practice to Evaluate Leaching of Water-Soluble Materials from Latex Paint Films*， 2023-10-01 Update
• ASTM D7306 Standard Practice for Testing Low Temperature Film-Formation of Latex Paints by Visual Observation*， 2017-06-01 Update
• ASTM D7489 Standard Practice for Evaluating Touch-Up Properties of Architectural Coatings under Various Environmental Conditions*， 2017-06-01 Update
• ASTM D7514 Standard Test Method for Evaluating Ink Stainblocking of Architectural Paint Systems by Visual Assessment*， 2022-12-01 Update
• ASTM D772 Standard Test Method for Evaluating Degree of Flaking (Scaling) of Exterior Paints
• ASTM D7786 Standard Test Method for Determining Enamel Holdout*， 2019-04-01 Update
• ASTM D869 Standard Test Method for Evaluating Degree of Settling of Paint
• ASTM D968 Standard Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive
• ASTM E105 Standard Practice for Probability Sampling Of Materials*， 2024-04-21 Update
• ASTM E1347 Standard Test Method for Color and Color-Difference Measurement by Tristimulus (Filter) Colorimetry
• ASTM E70 Standard Test Method for pH of Aqueous Solutions With the Glass Electrode

ASTM D5324-16 history

• 2022 ASTM D5324-16(2022) Standard Guide for Testing Water-Borne Architectural Coatings
• 2016 ASTM D5324-16 Standard Guide for Testing Water-Borne Architectural Coatings
• 2010 ASTM D5324-10 Standard Guide for Testing Water-Borne Architectural Coatings
• 2003 ASTM D5324-03 Standard Guide for Testing Water-Borne Architectural Coatings
• 1998 ASTM D5324-98 Standard Guide for Testing Water-Borne Architectural Coatings