1.1 These test methods cover tests for solvent containing varnishes primarily intended to provide electrical, mechanical, and chemical protection for electrical equipment. These test methods include tests for control and performance as follows: Procedure Section Build 38 – 42 Dielectric Strength 43 – 48 Drainage 26 – 32 Flash Point 18 – 20 Nonvolatile Matter 21 – 25 Oil Resistance 54 – 56 Preparation of Test Specimens 7 Specific Gravity 9 – 12 Temperature Index 49 – 50 Time of Drying 33 – 37 Varnish Compatibility 51 – 53 Viscosity 13 – 17
1.2 Where the entire test method is included in this standard, the precision and bias are not known unless given in the stated method.
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5. NOTE 1—There is no equivalent IEC standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM D115-17 Referenced Document
ASTM D1475 Standard Test Method For Density of Liquid Coatings, Inks, and Related Products
ASTM D149 Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
ASTM D1932 Standard Test Method for Thermal Endurance of Flexible Electrical Insulating Varnishes
ASTM D202 Standard Test Methods for Sampling and Testing Untreated Paper Used for Electrical Insulation
ASTM D2518 Standard Specification for Woven Glass Fabrics for Electrical Insulation
ASTM D2519 Standard Test Method for Bond Strength of Electrical Insulating Varnishes by the Helical Coil Test
ASTM D287 Standard Test Method for API Gravity of Crude Petroleum and Petroleum Products (Hydrometer Method)
ASTM D295 Standard Test Methods for Varnished Cotton Fabrics Used for Electrical Insulation
ASTM D3145 Standard Test Method for Thermal Endurance of Electrical Insulating Varnishes by the Helical Coil Method
ASTM D3251 Standard Test Method for Thermal-Aging Characteristics of Electrical Insulating Varnishes Applied Over Film-Insulated Magnet Wire
ASTM D3278 Standard Test Methods for Flash Point of Liquids by Small Scale Closed-Cup Apparatus
ASTM D3487 Standard Specification for Mineral Insulating Oil Used in Electrical Apparatus
ASTM D374 Standard Test Methods for Thickness of Solid Electrical Insulation
ASTM D5032 Standard Practice for Maintaining Constant Relative Humidity by Means of Aqueous Glycerin Solutions
ASTM D5423 Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation
ASTM D56 Standard Test Method for Flash Point by Tag Closed Tester
ASTM D580 Standard Specification for Greige Woven Glass Tapes and Webbings
ASTM D93 Standard Test Methods for Flash-Point by Pensky-Martens Closed Cup Tester
ASTM E104 Standard Practice for Maintaining Constant Relative Humidity by Means of Aqueous Solutions
ASTM D115-17 history
2024ASTM D115-17(2024) Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
2017ASTM D115-17 Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
2014ASTM D115-14 Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
2007ASTM D115-07(2012) Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
2007ASTM D115-07 Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
2002ASTM D115-02 Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation
1998ASTM D115-98 Standard Test Methods for Testing Solvent Containing Varnishes Used for Electrical Insulation