ASTM A667/A667M-87(2022) PDF

Scope: 1.1 This specification2 covers centrifugally cast cylinders with an outer layer of white cast iron and the remainder of the material of gray cast iron. These castings are suitable for pressure-containing parts, the design strength of which is based on the gray iron portion of the cylinder. These castings are suitable for service at temperatures up to 450 °F [230 °C]. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM A667/A667M-87(2022) Referenced Document

ASTM A278/A278M Standard Specification for Gray Iron Castings for Pressure-Containing Parts for Temperatures Up to 650 °F (350 °C)

2022 ASTM A667/A667M-87(2022) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders
2018 ASTM A667/A667M-87(2018) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders
1987 ASTM A667/A667M-87(2012) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders
1987 ASTM A667/A667M-87(2008) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders
1987 ASTM A667/A667M-87(2003) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders
1998 ASTM A667/A667M-87(1998) Standard Specification for Centrifugally Cast Dual Metal (Gray and White Cast Iron) Cylinders