ASTM D8034/D8034M-17 PDF

Scope: 1.1 This test method evaluates the effect of a circulating engine coolant on metal test specimens and automotive cooling system components under controlled, essentially isothermal laboratory conditions. 1.2 This test method specifies test material, cooling system components, type of coolant, and coolant flow conditions that are considered typical of current automotive use. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Some values have only SI units because the inch-pound equivalents are not used in practice. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8034/D8034M-17 Referenced Document

ASTM D1121 Standard Test Method for Reserve Alkalinity of Engine Coolants and Antirusts
ASTM D1123 Standard Test Methods for Water in Engine Coolant Concentrate by the Karl Fischer Reagent Method
ASTM D1176 Standard Practice for Sampling and Preparing Aqueous Solutions of Engine Coolants or Antirusts for Testing Purposes
ASTM D1193 Standard Specification for Reagent Water
ASTM D1287 Standard Test Method for pH of Engine Coolants and Antirusts
ASTM D2570 Standard Test Method for Simulated Service Corrosion Testing of Engine Coolants
ASTM D7935/D7935M Standard Test Method for Corrosion Test for Non-Aqueous Engine Coolants in Glassware*， 2024-04-21 Update
ASTM E203 Standard Test Method for Water Using Volumetric Karl Fischer Titration
SAE J20e Coolant System Hoses

2017 ASTM D8034/D8034M-17 Standard Test Method for Simulated Service Corrosion Testing of Non-Aqueous Engine Coolants
2016 ASTM D8034/D8034M-16 Standard Test Method for Simulated Service Corrosion Testing of Non-Aqueous Engine Coolants