ASTM D3038-93(2018) PDF

Scope: 1.1 This test method covers the application of two procedures for the determination of the property of coke of withstanding breakage when dropped under specified test conditions. 1.2 Procedure A, used when the coke sample contains 50 % or less of 100 mm (4 in.) after removal of coke smaller than 50 mm (2 in.). Procedure A appears in Sections 6 – 9. 1.3 Procedure B, used when the coke sample contains more than 50 % 100 mm (4 in.) after removal of coke smaller than 50 mm (2 in.). Procedure B appears in Sections 10 – 13. 1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3038-93(2018) Referenced Document

ASTM D121 Standard Terminology of Coal and Coke*， 2024-03-01 Update
ASTM D293 Standard Test Method for the Sieve Analysis of Coke
ASTM D346 Standard Practice for Collection and Preparation of Coke Samples for Laboratory Analysis
ASTM D4621 Standard Guide for Quality Management in an Organization That Samples or Tests Coal and Coke
ASTM E11 Standard Specification for Wire Cloth and Sieves for Testing Purposes
ASTM E323 Standard Specification for Perforated-Plate Sieves for Testing Purposes