ASTM F845-96 PDF

Scope: 1.1 This specification covers plastic insert fittings for polybutylene (PB) plastic tubing. These fittings are intended for use in 100-psi (6.9-MPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for materials, workmanship, burst pressure, sustained pressure, temperature cycling tests, and markings to be used on the fittings. 1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values stated in parentheses are provided for information purposes. 1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F845-96 Referenced Document

ASTM D1598 Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
ASTM D1599 Standard Test Method for Resistance to Short-Time Hydraulic Failure Pressure of Plastic Pipe, Tubing, and Fittings
ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
ASTM D1784 Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) Compounds and Chlorinated Poly(Vinyl Chloride) (CPVC) Compounds
ASTM D2122 Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
ASTM D3309 Standard Specification for Polybutylene (PB) Plastic Hot- and Cold-Water Distribution Systems
ASTM D4181 Standard Classification for Acetal (POM) Molding and Extrusion Materials
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM F1498 Standard Specification for Taper Pipe Threads 60° for Thermoplastic Pipe and Fittings*， 2020-11-01 Update
ASTM F412 Standard Terminology Relating to Plastic Piping Systems*， 2023-07-20 Update

2017 ASTM F845-96 Standard Specification for Plastic Insert Fittings for Polybutylene (PB) Tubing (Withdrawn 2003)