ASTM D8112-24
Standard Guide for Obtaining In-Service Samples of Turbine Operation Related Lubricating Fluid

Standard No.

ASTM D8112-24

Release Date

2024

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D8112-24

Scope

1.1  This guide is applicable for collecting representative fluid samples for the effective condition monitoring of steam and gas turbine lubrication and generator cooling gas sealing systems in the power generation industry. In addition, this guide is also applicable for collecting representative samples from power generation auxiliary equipment including hydraulic systems. 1.2  The fluid may be used for lubrication of turbine-generator bearings and gears, for sealing generator cooling gas as well as a hydraulic fluid for the control system. The fluid is typically supplied by dedicated pumps to different points in the system from a common or separate reservoirs. Some large steam turbine lubrication systems may also have a separate high pressure pump to allow generation of a hydrostatic fluid film for the most heavily loaded bearings prior to rotation. For some components, the lubricating fluid may be provided in the form of splashing formed by the system components moving through fluid surfaces at atmospheric pressure. 1.3  Turbine lubrication and hydraulic systems are primarily lubricated with petroleum based fluids but occasionally also use synthetic fluids. 1.4  For large lubrication and hydraulic turbine systems, it may be beneficial to extract multiple samples from different locations for determining the condition of a specific component. 1.5  The values stated in SI units are regarded as standard. 1.5.1  The values given in parentheses are for information only. 1.6  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7  This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8112-24 history

• 2024 ASTM D8112-24 Standard Guide for Obtaining In-Service Samples of Turbine Operation Related Lubricating Fluid
• 2022 ASTM D8112-22 Standard Guide for Obtaining In-Service Samples of Turbine Operation Related Lubricating Fluid
• 2017 ASTM D8112-17 Standard Guide for Obtaining In-Service Samples of Turbine Operation Related Lubricating Fluid