ASTM D8176-18 PDF

Scope: 1.1 This test method covers the determination of the mechanically tapped density of powdered and fine mesh activated carbon. For the purpose of this test method, “powdered carbon” is defined as having a mean particle diameter less than 45 µm, and “fine mesh carbon” is defined as having a particle size predominately between 80 and 325 U.S. Standard mesh. 1.2 The values in SI units are to be regarded as standard. No other units of measure are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D8176-18 Referenced Document

ASTM D2652 Standard Terminology Relating to Activated Carbon
ASTM D2867 Standard Test Methods for Moisture in Activated Carbon
ASTM D5158 Standard Test Method for Determination of Particle Size of Powdered Activated Carbon by Air-Jet Sieving*， 2019-08-01 Update
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E300 Standard Practice for Sampling Industrial Chemicals
ASTM E542 Standard Practice for Gravimetric Calibration of Laboratory Volumetric Instruments*， 2022-01-01 Update
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

2023 ASTM D8176-18(2023) Standard Test Method for Mechanically Tapped Density of Activated Carbon (Powdered and Fine Mesh)
2018 ASTM D8176-18 Standard Test Method for Mechanically Tapped Density of Activated Carbon (Powdered and Fine Mesh)