ASTM D6862-11(2021)
Standard Test Method for 90 Degree Peel Resistance of Adhesives

Standard No.

ASTM D6862-11(2021)

Release Date

2021

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D6862-11(2021)

Scope

1.1 This test method covers the determination of the resistance-to-peel strength of an adhesive bond between one rigid adherend and one flexible adherend when tested at an angle of approximately 90 degrees under specified conditions of preparation and testing. 1.2 A variation in thickness of the adherends will generally influence test values. For this reason, the thickness of the adherends used to make the test specimens shall be specified in the material specification. When no thickness is specified, the flexible adherend shall be 0.60 mm (0.025 in.) thick and the rigid adherend shall be 1.60 mm (0.060 in.) thick. NOTE 1—A heavy fabric, such as canvas, has been used as a flexible adherend. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1 This test method is under the jurisdiction of ASTM Committee D14 on Adhesives and is the direct responsibility of Subcommittee D14.10 on Working Properties. Current edition approved April 1, 2021. Published April 2021. Originally approved in 2003. Last previous edition approved in 2016 as D6862 – 11 (2016). DOI: 10.1520/D6862-11R21. Copyright © ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. 1 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6862-11(2021) Referenced Document

• ASTM D907 Standard Terminology of Adhesives*， 2023-05-16 Update
• ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
• ASTM E4 Standard Practices for Force Verification of Testing Machines

ASTM D6862-11(2021) history

• 2021 ASTM D6862-11(2021) Standard Test Method for 90 Degree Peel Resistance of Adhesives
• 2011 ASTM D6862-11(2016) Standard Test Method for 90 Degree Peel Resistance of Adhesives
• 2011 ASTM D6862-11 Standard Test Method for 90 Degree Peel Resistance of Adhesives
• 2004 ASTM D6862-04 Standard Test Method for 90 Degree Peel Resistance of Adhesives
• 2003 ASTM D6862-03 Standard Test Method for 90 Degree Peel Resistance of Adhesives