Introduction This standard defines a method for incorporating more than one source of control into a CAMAC crate. The standard fully conforms to the mechanical and signal standards of the CAMAC system as described in ANSI/IEEE Std 583-1975@ Modular Instrumentation and Digital Interface System (CAMAC)@ or EUR 4100e. In order to allow more than one Controller to access the Dataway of a CAMAC Criite@ an Auxiliary Controller Bus (ACE) and priority arbitration protocol are fully defined. This permits the use of Auxiliary Controllers (ACs) in normal stations in the crate. The ACB carries encoded address information from an AC to the Crate Controller (CC) in the control station of a CAMAC crate@ and carries Look-at- Me signals from the CC to the ACs. The ACB@ connected between controllers@ may also be used to establish priority for control of the CAMAC Dataway. This standard is fully compatible with ANSI/ IEEE Std 595-1976@ Serial Highway Interface System (CAMAC)@ or EUR 6100e@ and the ANSIAEEE Std 596-1976@ Parallel Highway Interface System (CAMAC) or EUR 4600e. It may also be used in autonomous systems (systems with no external highways) or in systems with Type U Crate Controllers (such as systems with a computer I/O bus as the highway). Section Al of the Appendix to this standard defines a Parallel Highway Crate Controller@ Type A-2. This controller is similar to Crate Controller Type A-1 (as defined in Section Al of the Appendix to ANSI/IEEE Std 596-1976 or EUR 4600e)@ except for the ACB connector and the priority arbitration protocol. When these two features are not required@ Crate Controllers Types A-1 and A-2 are totally interchangeable. Abbreviations used in this document are as follows: AC Auxiliary Controller ACB Auxiliary Controller Bus ACL Auxiliary Controller Lockout CC Crate Controller R/G Request Grant
IEEE 675-1979 history
1982IEEE 675-1982 Standard Multiple Controllers in a CAMAC Crate
1979IEEE 675-1979 Standard Multiple Controllers in a CAMAC Crate