ASTM C1054-18 PDF

Scope: 1.1 This practice covers the pressing and drying of chemically and non-chemically bonded alumin-silicate and highalumina plastic and ramming mix refractory specimens classified in accordance with Classification C673. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C1054-18 Referenced Document

ASTM C179 Standard Test Method for Drying and Firing Linear Change of Refractory Plastic and Ramming Mix Specimens
ASTM C181 Standard Test Method for Workability Index of Fireclay and High-Alumina Plastic Refractories
ASTM C673 Standard Classification of Fireclay and High-Alumina Plastic Refractories and Ramming Mixes*， 2022-09-01 Update

2018 ASTM C1054-18 Standard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens
2013 ASTM C1054-13 Standard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens
2008 ASTM C1054-03(2008) tandard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens
2003 ASTM C1054-03 Standard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens
1985 ASTM C1054-85(1995) Standard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens

$Standard Practice for Pressing and Drying Refractory Plastic and Ramming Mix Specimens$