ASTM F2837-11(2018) PDF

Scope: 1.1 This test method covers a means of measuring the hot compression properties of a gasket material by measuring its creep under a constant load at both room temperature and while increasing the temperature. Short term creep properties including both cold and hot creep, total creep and compression set of a gasket material can be determined. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F2837-11(2018) Referenced Document

ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM F104 Standard Classification System for Nonmetallic Gasket Materials*， 2020-01-01 Update

2018 ASTM F2837-11(2018) Standard Test Method for Hot Compression Properties of Gasket Materials
2011 ASTM F2837-11 Standard Test Method for Hot Compression Properties of Gasket Materials
2010 ASTM F2837-10 Standard Test Method for Hot Compression Properties of Gasket Materials