ASTM B507-14(2021) PDF

Scope: 1.1 This practice covers design information for parts to be electroplated on racks. The recommendations contained herein are not mandatory, but are intended to give guidance toward good practice. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM B507-14(2021) history

2021 ASTM B507-14(2021) Standard Practice for Design of Articles to Be Electroplated on Racks
2014 ASTM B507-14 Standard Practice for Design of Articles to Be Electroplated on Racks
1986 ASTM B507-86(2008)e1 Standard Practice for Design of Articles to Be Electroplated on Racks
1986 ASTM B507-86(2003) Standard Practice for Design of Articles To Be Electroplated on Racks
1998 ASTM B507-86(1998) Standard Practice for Design of Articles To Be Electroplated on Racks