ISO 18563-3:2024
Non-destructive testing

Standard No.

ISO 18563-3:2024

Release Date

2024

Published By

International Organization for Standardization (ISO)

Latest

ISO 18563-3:2024

Scope

This document addresses ultrasonic test systems implementing array probes, for contact technique (with or without wedge) or for immersion technique, with centre frequencies in the range of 0,5 MHz to 10 MHz. This document provides methods and acceptance criteria for determining the compliance of the complete system (see 3.2). Its purpose is for the verification of the correct operation of the system prior to testing or verification of the absence of degradation of the system. Themethodsarenotintendedtoprovethesuitabilityofthesystemforparticularapplicationsbutareintended to prove the capability of the complete system (used for an application) to operate correctly according to the settings used. Tests can be performed on individual ultrasonic beams (for phased array technique, see 9.4.4) or on resulting images (for phased array technique and total focusing technique, see 9.4.3). The tests can be limited to the functions that are intended to be used for a certain application. This document does not cover the sensitivity setting of the system for a specific application. Nor does it apply to the characterization or verification of the mechanical scanning equipment. It is intended that these items will be covered by the test procedure. This document does not address the phased array technique using tandem technique. The characterization of beams, as recommended in case of dead elements or for more in-depth knowledge of the beams, is presented in Annex A. It is not applicable for signal processing technology using arrays. NOTE Unless stated otherwise, in this document ‘TFM’ and ‘TFM technique’ refer to the total focusing technique as defined in ISO 23243, and to related techniques, see for example ISO 23865 and ISO 23234.

ISO 18563-3:2024 Referenced Document

• ISO 18563-1 Non-destructive testing — Characterization and verification of ultrasonic phased array equipment — Part 1: Instruments
• ISO 18563-2 Non-destructive testing — Characterization and verification of ultrasonic phased array equipment — Part 2: Array probes*， 2024-09-01 Update
• ISO 22232-2 Non-destructive testing — Characterization and verification of ultrasonic test equipment — Part 2: Probes
• ISO 23243 Non-destructive testing - Ultrasonic testing with arrays - Vocabulary
• ISO 5577 Non-destructive testing - Ultrasonic testing - Vocabulary
• ISO 9712 Non-destructive testing — Qualification and certification of NDT personnel

ISO 18563-3:2024 history

• 2024 ISO 18563-3:2024 Non-destructive testing
• 2015 ISO 18563-3:2015 Non-destructive testing - Characterization and verification of ultrasonic phased array equipment - Part 3: Combined systems

Topics on standards and specifications

Standard and Specification