SAE J737-2007
Hole Spacing for Scraper and Dozer Cutting Edges
- Standard No.
- SAE J737-2007
- Release Date
- 2007
- Published By
- SAE - SAE International
- Status
- 2007-08
- Latest
- SAE J737-2007
- Scope
- This standard is intended for cutting edge sections used on: a. Tractor-scrapers as described in SAE J1057 and J728. b. Dozers as described in SAE J729. These cutting edges are further defined in SAE J738 for cross section and SAE J740 and J1580 for hole conformation. NOTE??Some inch dimensions in this standard are not equivalent to the corresponding millimeter figures because values which are widely used have been adapted. Purpose?? This standard specifies hole placement along with length and width of the cutting edge. Rationale??Superseded by ISO 7129. Rationale?? Superseded by ISO 7129.
SAE J737-2007 history
- 2007 SAE J737-2007 Hole Spacing for Scraper and Dozer Cutting Edges
- 2006 SAE J737-2006 Hole Spacing for Scraper and Dozer Cutting Edges
- 1989 SAE J737-1989 Hole Spacing for Scraper and Dozer Cutting Edges, Standard August 1989
- 1983 SAE J737-1983 Hole Spacing for Scraper and Dozer Cutting Edges
