ASTM D953-19 PDF

Scope: 1.1 This test method covers the determination of the pinbearing strength of rigid plastics in either sheet form, molded form, or in reinforced thermoset form. Procedures A and B are applicable for thermoplastic materials in tension loading and compression loading respectively. Procedure C is applicable for thermoset reinforced plastics. See the significance and use section (Section 5) for cautions in using this test standard. 1.2 Test data obtained by this test method is relevant and appropriate for use in quality control and engineering design. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 1—This standard and ISO 12815 address the same subject matter, but differ in technical content. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D953-19 Referenced Document

ASTM D5947 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM D7290 Standard Practice for Evaluating Material Property Characteristic Values for Polymeric Composites for Civil Engineering Structural Applications*， 2022-02-01 Update
ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E4 Standard Practices for Force Verification of Testing Machines
ASTM E6 Standard Terminology Relating to Methods of Mechanical Testing
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO 12815 Fibre-reinforced plastic composites - Determination of plain-pin bearing strength