ASTM D1177-22 PDF

Scope: 1.1 This test method covers the determination of the freezing point of an aqueous engine coolant solution in the laboratory. NOTE 1—Where solutions of specific concentrations are to be tested, they shall be prepared from representative samples as directed in Practice D1176. Secondary phases separating on dilution need not be separated. NOTE 2—These products may also be marketed in a ready-to-use form (prediluted). 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D1177-22 Referenced Document

ASTM D1176 Standard Practice for Sampling and Preparing Aqueous Solutions of Engine Coolants or Antirusts for Testing Purposes
ASTM E1 Standard Specification for ASTM Thermometers

2022 ASTM D1177-22 Standard Test Method for Freezing Point of Aqueous Engine Coolants
2017 ASTM D1177-17 Standard Test Method for Freezing Point of Aqueous Engine Coolants
2016 ASTM D1177-16 Standard Test Method for Freezing Point of Aqueous Engine Coolants
2012 ASTM D1177-12 Standard Test Method for Freezing Point of Aqueous Engine Coolants
2007 ASTM D1177-07 Standard Test Method for Freezing Point of Aqueous Engine Coolants
2005 ASTM D1177-05 Standard Test Method for Freezing Point of Aqueous Engine Coolants
1994 ASTM D1177-94(1998)e1 Standard Test Method for Freezing Point of Aqueous Engine Coolants
1998 ASTM D1177-94(1998) Standard Test Method for Freezing Point of Aqueous Engine Coolants